Azcue MN Close Coupled Centrifugal Pump

The Azcue MN Close Coupled Centrifugal Pump is similar in design to the CP, but a larger, more robust horizontal centrifugal pump with larger flow and pressure capabilities and that can handle higher temperature fluids. Based on DIN 24255, the Azcue MN is dimensionally the same as other pumps allowing it to easily replace existing single stage centrifugal pumps from other manufacturers in applications involving relatively clean fluids such as water and low viscosity fuels.

The Azcue MN horizontal centrifugal pump benefits from a back pull out design, allowing the motor to be removed without disconnecting the pump from the pipework, saving time during maintenance. Whilst being closed coupled, this centrifugal water pump has a lantern bracket, which means that whilst being of more compact construction, there is still space between the pump and motor so should the seal fail fluid will not enter the motor. Thanks to the addition of wear rings,  there is small clearance between the impeller and pump casing preventing wear to these parts. Wearing rings are designed to be changed every now and then to prevent the more costly replacement of the impeller or casing.

These Azcue pumps have separate shafts in the pump head and motor meaning that if there is ever an issue with one shaft, there is no need to replace it all; a benefit over other pumps on the market that have one continuous shaft from head to motor. If required, the MN horizontal centrifugal pump is available with an external vacuum or electric priming pump. For longer suction distances, a vacuum priming pump would be the better solution thanks to its ability to dry run for short periods of time.

Features of the Azcue MN Single Stage Centrifugal Pump:

• Close coupled, single stage centrifugal pump
• DIN 24255 dimensions for easy retrofitting
• Pump manufactured in Spain
• Marine type approved by all classification societies
• Compact horizontal design ideal for space saving installations
• Available in cast iron, 316 stainless steel and bronze for seawater
• Lantern bracket providing some space between pump head and motor
• Back pull out design for simple maintenance
• Separate shafts in the pump and motor
• Low NPSH
• Casing wear rings to prolong casing and impeller life
• 230v, three phase 50Hz/60Hz motors available. IP55 as standard.
• Available with a vacuum or electric priming pump on request
• Assembly without alignment
• Supplied flanged as standard
• ATEX versions available